Min pitch differs by profile
Custom Orb, Trimdek, Kliplok. Each has a different minimum pitch. Get the right number for the sheet profile before the truck leaves the yard.
The AI for roofers
Metal profiles, fall protection, flashings, battens. Tailored to ACT rules, citing Access Canberra.
Know the rules. Move fast.
Less clause hunting. Cleaner workflow. Complex rules managed without PDF scrolling or regulator phone calls.
Custom Orb, Trimdek, Kliplok. Each has a different minimum pitch. Get the right number for the sheet profile before the truck leaves the yard.
Over 2m, over 4m, penetrations, edge work. The rules layer WHS Reg with AS/NZS 4994. Get the integrated answer for the specific job height.
Corrosion category or bushfire-attack level flips the spec. Get the coating + fastener answer tied to the site location so the roof lasts the warranty.
Ask like a roofer
Tap any prompt to start. Every answer cites the clause, the standard, and the state variation where it applies.
A day on the tools
Each scenario is a real compliance question, with the clause Standardsmate™ would cite in its answer.
“Custom Orb on a shed at 5 degrees. Is that enough pitch, or do I need a different profile?”
“Two-storey reroof, 4m to the gutter. Do I need full perimeter guardrail?”
“Installing a Velux on a tile roof. Upstand height and side flashing detail?”
Related
Slug: /for/roofers-in-act